Skip to content
MeasureToBuy

Project planner

Insulate an attic

Find the R-value ENERGY STAR recommends for your climate zone, then count the bags of batts or blown-in insulation to reach it from the manufacturer's coverage chart.

  1. 01 Attic size
  2. 02 Target R-value
  3. 03 Batts or blown-in
  4. 04 Cost
  5. 05 Summary
  1. Step 1: Attic size

    Measure the attic floor — the ceiling area of the rooms below.

    Attic or floor: length × width. Walls: length × height, less windows and doors.

  2. Step 2: Target R-value

    ENERGY STAR's recommendation depends on your climate zone and what's already there.

    IECC climate zone for US counties — look yours up on the ENERGY STAR or DOE climate zone map.

    You're installing
    R-30
    ENERGY STAR recommendsZone 5, uninsulated attic
    R-60
  3. Step 3: Batts or blown-in

    Bags come from the manufacturer's coverage chart. Blown-in must also reach the chart's minimum depth.

    Insulation type
    Waste allowance

    Rule of thumb for batts cut around framing, pipes and wiring.

    Area
    1,000 sq ft
    Waste allowance
    5%
    Area with waste
    1,050 sq ft
    Coverage per bagJohns Manville fact sheet
    88 sq ft
    Bags to buy
    12 bags
  4. Step 4: Cost

    Seal air leaks first — it's cheap and insulation doesn't stop air.

    per bag
    Insulation
    $540.00
    Air sealing
    $40.00
    Estimated material cost
    $580.00

MeasureToBuy · project summary

Attic insulation project

You need 12 bags of R-30 insulation.

Measurements

  • Area to insulate: 1000 sq ft
  • Climate zone: Zone 5
  • The attic already has 3–4 in of insulation: No
  • Insulation type: Batts or rolls
  • Batt product: R-30, 24 in wide

Key figures

You're installing
R-30
ENERGY STAR recommendsZone 5, uninsulated attic
R-60

Shopping list

Bags to buy
12 bags

Material cost

Insulation
$540.00
Air sealing
$40.00
Estimated material cost
$580.00

That's below the ENERGY STAR recommendation of R-60 for this zone. In an attic you can layer a second run of unfaced batts across the first, or blow loose fill over existing insulation. Seal air leaks around pipes, wires, recessed lights and the attic hatch before insulating — insulation doesn't stop air movement.

Calculators provide planning estimates. Actual material requirements vary with product specifications, installation method, site conditions, local codes and project complexity.

Before you start

  • Look up your IECC climate zone and measure the attic floor.
  • Seal air leaks around pipes, wires, flues and the hatch before adding insulation.
  • Check for knob-and-tube wiring, vermiculite, damp or mold — those need a professional first.

Questions about this project

Batts or blown-in for an attic?

Blown-in fills around wiring and irregular joists and is quicker over a large attic; batts are easy to handle in small or open spaces. Both reach the same R-value when installed to the chart.

Can I rent a blower?

Many home centers lend or rent a blowing machine with a minimum purchase of blown-in bags — check the store's terms.

Calculators used in this project

Need just one number? Each step is also a stand-alone calculator.